![]() (which gets audio by loopback from HW output AES). Ok, so to record this in Wavelab: I have loaded the ASIO driver and my input signal is HW Input AES (and if you would like to record it you can use again loopback) This is intentionally by design, to make it still possible to see audio arriving on the real HW input AES.Īnd here you have even two possibilities:Ī) you can now record on HW Input AES the looped back audio signal from HW output AES andī) you can still route any audio arriving on the physical port HW Input AES to any other output Note: in TM FX you do not see audio from loopback on the HW input AES. (because my active monitors are connected to an ADI-2 Pro, which is connected to the AES port).Īs Wavelab can not record audio from HW Output AES, I have to activate loopback on this output.Īudio can now be recorded on the corresponding input: HW Input AES. In TM FX you see audio in the middle row: SW Playback Channel AN 1/2 which I route to HW Output AES If I want to record something from Youtube, then Windows sends audio to its default sound device Analog 1/2 OUT. To put an example which works for me well as a basis: As you are mentioning WDM drivers please note, that Wavelab can only load ASIO drivers, not Windows or WDM drivers. There is something fundamentally wrong I am doing here and posting this to gain some knowledge. Now when I try to record something, I do not get any sound. Also, in WaveLab, I have defined MADI 3+4 and Playback device. I have defined MADI 1+2 as WDM and also as channels to record in WaveLab. I have a MADIFace USB connected to a Win 10 computer that has Steinberg WaveLab. There is most probably something that I do not understand.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |